Electric vehiclesTaiwan: Draft of Technical Specification for Verification and Inspection of Electric Vehicle Supply Equipment

February 23, 20220

Taiwan: Draft of Technical Specification for Verification and Inspection of Electric Vehicle Supply Equipment

 

Yesterday, we informed that Taiwan published a Proposal for Amendments to Regulations Governing Verification and Inspection of Measuring Instruments.  In accordance with the proposal, electric vehicle supply equipment would become subject to this legal act as well.

Today, Taiwan published additionally a Draft of Technical Specification for Verification and Inspection of Electric Vehicle Supply Equipment.

In accordance with the draft, the following information should be placed on the nameplate of the equipment:

(1) The manufacturer’s name, initials, trademark or distinctive marking.
(2) Type designation or identification number or any other means of
identification, making it possible to obtain relevant information from
the manufacturer of the electric vehicles supply equipment.
(3) Serial number or manufacturing number.
(4) Identification of manufacturing date.
(5) Type of electric current.
(6) Frequency and number of phases in case of alternating current.
(7) Rated voltage (input and output respectively, if not the same).
(8) Rated current (input and output respectively, if not the same).

Additionally, the verification mark shall be attached with a physical adhesive tamper-evident on the opening of outer covering of the metering module to prevent tampering with metering functions. The physical adhesive tamper-evident shall be attached to the adequate place depending on the opening method of the equipment, and the verification mark shall be attached on the obvious place on the front of the electric vehicles supply equipment.

Moreover, verification and inspection methods, and maximum permissible errors are described in the draft.

The draft is formulated with reference to the following international regulations and specifications:

(1) IEC 62052-11:2020 Electricity metering equipment – General requirements, tests and test conditions – Part 11 : Metering equipment.

(2) IEC 62053-21:2016 Electricity metering equipment (a.c.) – Particular requirements –Part 21 : Static meters for active energy (classes 1 and 2).

(3) IEC 62053-41:2020 Electricity metering equipment – Particular requirements –Part 41 : Static meters for DC energy (classes 0,5 and 1).

(4) National Institute of Standards and Technology Handbook 44, §3.40, 2019.

(5) PTB-A 50.7 Anforderungen an elektronische und softwaregesteuerte Messgeräten und Zusatzeinrichtungen für Elektrizität, Gas, Wasser und Wärme.

(6) CNS 15511-1:2021 Electric vehicle conductive charging system – Part 1: General requirements + Amendment 1

(7) CNS 14607:2017 Static electricity meters

Leave a Reply

https://igarr.com/wp-content/uploads/2023/09/Logo2.jpeg
Kunstlaan / Avenue des Arts 56, Brussels
Plaza MallDova, 21, Arborilor str., Chisinau
Atrium Centrum, Al. Jana Pawła II 27, 00-867 Warsaw
+48 575 570 017

Follow us:

The content provided on this website is not intended to and does not constitute legal advice. Submissions or postings to the website are not confidential. We do not warrant or guarantee the accuracy, completeness or adequacy of the content. Your use of the content on the website or materials linked from this website is at your own risk.

Copyright © Institute for Global Automotive Regulatory Research 2024

en_USEnglish